I'll admit it's been a while since I last did any soldering, being a bit of a breadboard/Arduino addict but was wondering if the RF shield is earthed and therefore connected to the GND pin. The reason I ask is that this is the one pin I was overly generous with the solder when attaching the headers and if the shield isn't grounded, I'm getting a short, despite trying to reverse as much of the damage as possible.
TIA
Is RF Shield earthed?
- danicampora
- Posts: 342
- Joined: Tue Sep 30, 2014 7:20 am
- Contact:
Re: Is RF Shield earthed?
Many thanks for the response. I took a good look under a strong magnifying glass and I think I'd removed the excess solder so went for it anyway and powered it up...all good and can telnet in. Let the fun begin.
Thanks again.
Thanks again.