I'm fairly certain (based on other threads, and the values he's quoted that match) that they're working from:
https://github.com/KittenBot/micropytho ... figboard.h
I'm fairly certain (based on other threads, and the values he's quoted that match) that they're working from:
I have this one: https://reference.digilentinc.com/refer ... redirect=1. Specs on the right.jimmo wrote: ↑Fri May 24, 2019 5:14 amAlso, maybe a bit of a long shot, but back to the MCO idea -- you said "my logical analyzer doesn't have enough bandwidth I presume". What do you have? Can you set the divider down low enough? Like you just need a pulse counter? Any other dev boards sitting around?
Yes this is the one.jimmo wrote: ↑Fri May 24, 2019 5:15 amI'm fairly certain (based on other threads, and the values he's quoted that match) that they're working from:
https://github.com/KittenBot/micropytho ... figboard.h
Yes....just. In logic analyser mode at 10MS/s. With the /5 divider on MCO, you'll either get 1.6MHz or 2.4MHz. You'll get a pretty messy looking square wave because the pulses will be different widths, but you should at least be able to tell the frequency.shazz wrote: ↑Fri May 24, 2019 3:02 pmI have this one: https://reference.digilentinc.com/refer ... redirect=1. Specs on the right.
Do you think I can use it to measure out the SYSCLK and HSE frequencies ?