Hi Guys
I'm new in here, I just deploy MicroPython on STM32F429 DISC by this command: $ make BOARD=STM32F4DISC deploy-stlink,
and result as below:
http://imgur.com/9tI4sEf
My question is :
1. am I successfully deploy MicroPython?
2.if yes, How can I run REPL on STM32F429 DISC (I just connect RX to A9 and TX to A10 but there is no message on the screen...)
REPL on STM32F429 DISC
-
- Posts: 363
- Joined: Sun Apr 17, 2016 1:55 pm
Re: REPL on STM32F429 DISC
Plug in usb in both USB, miniUSB for STlink and macroUSB for pyboard.
-
- Posts: 463
- Joined: Wed Apr 08, 2015 5:19 am
Re: REPL on STM32F429 DISC
Are you sure you are using the right board definition? The STM32F4DISC definition is for the older STM32F4DISCOVERY board with a STM32F407 cpu. This board was succeeded by the STM32F407G-DISC1 board.
Re: REPL on STM32F429 DISC
The correct board definition for the STM32F429 Discovery is STM32F429DISC not STM32F4DISC. The 429 discovery board has an LCD on it.kobeyu wrote:I just deploy MicroPython on STM32F429 DISC by this command: $ make BOARD=STM32F4DISC deploy-stlink