Hi all,
I'm experimenting with MicroPython on a custom CC3200 board.
I built successfully out of master and programmed release bootloader, application images successfully
The board boots into AP mode and I can use the command line interface at 192.168.1.1 successfully
However when I try to set up STA mode I can't connect
e.g. wlan.connect('my_ssid', auth=(net.sec, 'my_wifi_key'), timeout=5000)
This times out, without the timeout parameter it just blocks.
I wondered if anybody can offer any advice how I can dig into this to resolve it?
Thanks, Alex