Thank you for the reply.
I am using Thonny 3.3.2 and MicroPython v1.13-268-gf7aafc062 on 2021-01-08.
The board is nodeMCU v3.
It works very well over serial.
Thank you again.
Search found 4 matches
Search found 4 matches • Page 1 of 1
Hi everyone, I activated webrepl in boot.py, did the reset, then I did the webrepl_setup when the boot was done. At the end of the setup I got these messages: ERROR thonny.plugins.micropython.backend: PROBLEM WITH THONNY'S BACK-END: Traceback (most recent call last): File "C:\....\Thonny\lib\site-pa...
- Mon Jan 11, 2021 8:24 pm
- Forum: General Discussion and Questions
- Topic: help('modules'), nodeMCU, Thonny
- Replies: 2
- Views: 545
Hi, I am new with microPython and I consider this a good excuse for my post. I just installed Thonny 3.3 and microPython on nodeMCU v3. Following the invitation to type help(obj) with help('modules'), I got this list: __main__ machine ubinascii ure _boot math ucollections urequests _onewire micropyt...