WiPy dead after connecting SafeBoot pin with VIN

[Peter.Kenyon]

apologies newbie excuse

[andrew]

pyboard.bootloader()

That only works in the pyboard, not in the WiPy. Make sure to be browsing the WiPy docs:

http://micropython.org/resources/docs/e ... index.html

And not the ones from the pyboard.

I think the docs still need some cleaning up. For instance the math module is available from the module index and the a-z page: http://micropython.org/resources/docs/e ... odule-math and sys.platform should be "WiPy".

Andrew

[danicampora]

I think the docs still need some cleaning up. For instance the math module is available from the module index and the a-z page: http://micropython.org/resources/docs/e ... odule-math and sys.platform should be "WiPy".

Yes that's correct, thanks for the feedback. The multiboard support on the docs still needs a bit of tweaking.

[Sebastian]

I did exactly the same....
Now the WiPy is booting from factory firmware all the time.
Is there any chance to change the SafeBoot pin?

[andrew]

I did exactly the same....
Now the WiPy is booting from factory firmware all the time.
Is there any chance to change the SafeBoot pin?

I tried pulling it down to ground with a wire to the ground pin but that didn't work for me - it's worth trying though. Otherwise as I say mine starting working again on its own after a few days. Very mysterious.

Andrew

[Sebastian]

I tried the same but only factory firmware is booting at the moment.
The rest seems to work normal. I can execute files and WLAN is working but i'm not sure why the Blynk samples are not working.
Now i have to wait for my ordered replacement wipys.

[danicampora]

Blynk examples require the latest firmware.