Is the Advanced Low-Power Modes correct?
Posted: Fri Feb 26, 2016 7:03 pm
Hi all.
Are there differences between information of TI and the WiPy kickstarter page:
* About the TI: http://www.ti.com/product/CC3200
---------------------
Advanced Low-Power Modes
Hibernate: 4 µA
Low-Power Deep Sleep (LPDS): 250 µA
RX Traffic (MCU Active): 59 mA @ 54 OFDM
TX Traffic (MCU Active): 229 mA @ 54 OFDM,
Maximum Power
Idle Connected (MCU in LPDS):
825 µA @ DTIM = 1
---------------------
* About the TI: https://www.kickstarter.com/projects/wi ... escription
>>> Ultra-Low Power (with WiFi still connected!)
In that part there are a table where say: "Active | Yes | 14mA"
So, what is the correct? 14mA in active mode or 59mA/229mA.
Could you clarify that, please?
Thank you.
Are there differences between information of TI and the WiPy kickstarter page:
* About the TI: http://www.ti.com/product/CC3200
---------------------
Advanced Low-Power Modes
Hibernate: 4 µA
Low-Power Deep Sleep (LPDS): 250 µA
RX Traffic (MCU Active): 59 mA @ 54 OFDM
TX Traffic (MCU Active): 229 mA @ 54 OFDM,
Maximum Power
Idle Connected (MCU in LPDS):
825 µA @ DTIM = 1
---------------------
* About the TI: https://www.kickstarter.com/projects/wi ... escription
>>> Ultra-Low Power (with WiFi still connected!)
In that part there are a table where say: "Active | Yes | 14mA"
So, what is the correct? 14mA in active mode or 59mA/229mA.
Could you clarify that, please?
Thank you.