Wipy does not work -> what to do?

Questions and discussion about The WiPy 1.0 board and CC3200 boards.
Target audience: Users with a WiPy 1.0 or CC3200 board.
Post Reply
Deathwatch
Posts: 3
Joined: Mon Oct 12, 2015 2:04 pm

Re: Wipy does not work -> what to do?

Post by Deathwatch » Wed Oct 14, 2015 3:36 pm

Ok I found fault. The solder joint for the GND was cold I inspected the joint under a strong microscope and the solder was barley making contact with the pin. I assume the 5v were too much for so little contact surface. Thanks anyway

Cheers Marco
Top
Post Reply

Return to “WiPy and CC3200 boards”