[Espruino pico] Info about power/data connection

Discussion and questions about boards that can run MicroPython but don't have a dedicated forum.
Target audience: Everyone interested in running MicroPython on other hardware.
Post Reply
scardig
Posts: 21
Joined: Wed Jan 10, 2018 8:32 am

[Espruino pico] Info about power/data connection

Post by scardig » Mon Apr 19, 2021 2:40 pm

Hello,

I need to install micropython on the Espruino Pico and I need to use pin B6 and B7 (as here https://www.espruino.com/Pico ) to communicate with a UART device but I need to know if such pins will became a console mirror once only power is fed via usb (only +5V and GND connected). Is this the case ?

Thanx

Post Reply