[Nucleo- F411RE] Setting Up To Work With Putty
Posted: Mon Jul 19, 2021 7:18 pm
*Full initial disclosure - I am quite new to the coding community and this is my first time setting up an MCU, so please bear with me*
I am attempting to set up an STM32F411RE with micropython and to be able to use the board with PuTTY for an easier coding experience in the future. I have successfully downloaded the micropython .dfu file for the F411re board from the micropython website and uploaded to the board using DFU. At this point however I am not quite sure how to proceed to get putty to successfully communicate with the board. I have the com port in the putty terminal matching with the corresponding com port on the device manager, but no response when I open up the Putty terminal.
Any help would be greatly appreciated!
I am attempting to set up an STM32F411RE with micropython and to be able to use the board with PuTTY for an easier coding experience in the future. I have successfully downloaded the micropython .dfu file for the F411re board from the micropython website and uploaded to the board using DFU. At this point however I am not quite sure how to proceed to get putty to successfully communicate with the board. I have the com port in the putty terminal matching with the corresponding com port on the device manager, but no response when I open up the Putty terminal.
Any help would be greatly appreciated!