Porting to Atmel Sam4E16E/C
Posted: Mon Oct 10, 2016 11:05 pm
Hey everyone,
Got my hands on a pyboard and its pretty awesome. I am currently using the Atmel chip listed above which is the same M4 uC as the pyboard just Atmel vs. STM.
First question is if I wanted to attempt to use the pyboards dfu on the atmel chip would there be a chance it would take ? (I know the peripherals might not work at all) I figured I might be able to just use the dFuse util but I cant really figure out how to get the SAM4E eval board I have into dfu mode (if it is possible that is). To even attempt trying to load that firmware in.
Second if I wanted to attempt to port it over to the SAM4E16C I am not 100% sure where to start. Most of my experience is in just programming at a higher level not down at the bootloader/chip.
Thanks, any direction would be great! Or if anyone has already attempted and has something basic working that would be great also.
Got my hands on a pyboard and its pretty awesome. I am currently using the Atmel chip listed above which is the same M4 uC as the pyboard just Atmel vs. STM.
First question is if I wanted to attempt to use the pyboards dfu on the atmel chip would there be a chance it would take ? (I know the peripherals might not work at all) I figured I might be able to just use the dFuse util but I cant really figure out how to get the SAM4E eval board I have into dfu mode (if it is possible that is). To even attempt trying to load that firmware in.
Second if I wanted to attempt to port it over to the SAM4E16C I am not 100% sure where to start. Most of my experience is in just programming at a higher level not down at the bootloader/chip.
Thanks, any direction would be great! Or if anyone has already attempted and has something basic working that would be great also.