[wt51822_s4at] getting started
Posted: Thu Jul 19, 2018 7:54 am
I noticed the NRF port has now been merged! Woo!
https://github.com/micropython/micropyt ... /ports/nrf
In the readme it lists wt51822_s4at as one of the tested boards. I have one of these!
I used this breakout board on Oshpark to make it breadboard compatible:
https://oshpark.com/shared_projects/lRnmz9t2
I was wondering what the steps are to flash MicroPython to the device. The readme lists Manual under Flash util.
I don't have a Segger, but I do have a St-link (clone). Could I use that?
Any tips?
https://github.com/micropython/micropyt ... /ports/nrf
In the readme it lists wt51822_s4at as one of the tested boards. I have one of these!
I used this breakout board on Oshpark to make it breadboard compatible:
https://oshpark.com/shared_projects/lRnmz9t2
I was wondering what the steps are to flash MicroPython to the device. The readme lists Manual under Flash util.
I don't have a Segger, but I do have a St-link (clone). Could I use that?
Code: Select all
cd ports/nrf
./drivers/bluetooth/download_ble_stack.sh
make BOARD=wt51822_s4at SD=s110 sd
make BOARD=wt51822_s4at flash