Page 1 of 1


Posted: Sat Aug 11, 2018 2:13 pm
by msam
Hi all,
I am trying to develop using a custom nrf52 module.This module has no low frequency xtal.
It is possible to configure micropython to run on this specific hardware ?
I'm currently running micropython on Nordic pca10040 but would like to use non-Nordic hardware.

Re: [nrf52]

Posted: Sat Aug 11, 2018 7:41 pm
by c45713
I'm not sure of your use-case, but if you are thinking of running the SD without LF XTAL, you could try running it with RC. This can be achived by adding the

Code: Select all

in the For inspiration this is a similar configuration: ...

Re: [nrf52]

Posted: Fri Aug 17, 2018 5:23 pm
by msam
Hi c45713,

Your solution is correct: ... f83557d710