STM32F407 Discovery not boot to

Discussion and questions about boards that can run MicroPython but don't have a dedicated forum.
Target audience: Everyone interested in running MicroPython on other hardware.
Post Reply
Posts: 1
Joined: Sat Mar 28, 2020 10:38 am

STM32F407 Discovery not boot to

Post by billykai » Sat Mar 28, 2020 10:45 am

After I flash STM32F407 Discovery by DFU
and write program in
with complete ( such as blinky program)
after I disconnect and connect it again via usb
but why program didn't start up to ?
( no blinky as start up )
then I must re start by running program via thonny ide again.
What will I must do to running as start up for this STM32F407 Discovery

( I have experience to run micropython via esp32 that will run on startup as I want , but for this STM32F407 , it's not the same as I want)

User avatar
Posts: 2059
Joined: Tue Aug 08, 2017 1:57 am
Location: Sydney, Australia

Re: STM32F407 Discovery not boot to

Post by jimmo » Mon Mar 30, 2020 1:06 am


I haven't used Thonny but from other questions on the forum it sounds like it's default behavior is to just run the code from RAM rather than copying the file to the device. You either need to find a way to tell Thonny to actually copy the file, or use another tool such as or rshell to do it.

Post Reply