[W600 pico] Power supply

Discussion and questions about boards that can run MicroPython but don't have a dedicated forum.
Target audience: Everyone interested in running MicroPython on other hardware.
Post Reply
ichtar
Posts: 3
Joined: Mon Mar 01, 2021 10:14 am

[W600 pico] Power supply

Post by ichtar » Mon Mar 01, 2021 10:17 am

Hi all,

Not sure if it is off topic as it is not micropython related.
But I have a hard time finding how to power supply w600 pico outside from the micro usb port.
Any help appreciated as I find only output voltage pins.

Thanks

User avatar
Roberthh
Posts: 3667
Joined: Sat May 09, 2015 4:13 pm
Location: Rhineland, Europe

Re: [W600 pico] Power supply

Post by Roberthh » Mon Mar 01, 2021 12:45 pm

At the board there is a pin labeled 5V. Using that pin and GND you can supply the board. Suitable input voltages are 3.6 - 6 V. Do not exceed 6V as that will damage the regulator,

ichtar
Posts: 3
Joined: Mon Mar 01, 2021 10:14 am

Re: [W600 pico] Power supply

Post by ichtar » Tue Mar 02, 2021 7:55 am

Thanks for this quick answer it clarify things !
(I was connecting it to my arduino and I noticed that arduino got power from this 5v pin so I got confused.)

Post Reply