New to ESP8266 and micropython

All ESP8266 boards running MicroPython.
Official boards are the Adafruit Huzzah and Feather boards.
Target audience: MicroPython users with an ESP8266 board.
Post Reply
draxi
Posts: 2
Joined: Mon May 17, 2021 2:32 pm

New to ESP8266 and micropython

Post by draxi » Mon May 17, 2021 2:43 pm

Hello guys and girls. I'm pretty new to programming ESP8266 boards, and micropython.
I've been struggling to get my board to boot up.

Whenever I try to boot it up, I get loads of these stuff looping.
Image
Sometimes it boots straight away, and is ready to use. Sometimes I get a few loops of this stuff, then it's ready to use.
Sometimes it just loops and loops, and I gave to reset my board to try again.

Anyone know what I should do? Tried googling my way, but can't find any clues.

User avatar
Roberthh
Posts: 2700
Joined: Sat May 09, 2015 4:13 pm
Location: Rhineland, Europe

Re: New to ESP8266 and micropython

Post by Roberthh » Mon May 17, 2021 5:22 pm

That looks like an unstable power supply. Get a better cable and/or try another USB port.

draxi
Posts: 2
Joined: Mon May 17, 2021 2:32 pm

Re: New to ESP8266 and micropython

Post by draxi » Mon May 17, 2021 5:50 pm

Roberthh wrote:
Mon May 17, 2021 5:22 pm
That looks like an unstable power supply. Get a better cable and/or try another USB port.
You were absolutely correct good sir! Thank you so much!

Post Reply