New to ESP8266 and micropython
Posted: Mon May 17, 2021 2:43 pm
Hello guys and girls. I'm pretty new to programming ESP8266 boards, and micropython.
I've been struggling to get my board to boot up.
Whenever I try to boot it up, I get loads of these stuff looping.
Sometimes it boots straight away, and is ready to use. Sometimes I get a few loops of this stuff, then it's ready to use.
Sometimes it just loops and loops, and I gave to reset my board to try again.
Anyone know what I should do? Tried googling my way, but can't find any clues.
I've been struggling to get my board to boot up.
Whenever I try to boot it up, I get loads of these stuff looping.
Sometimes it boots straight away, and is ready to use. Sometimes I get a few loops of this stuff, then it's ready to use.
Sometimes it just loops and loops, and I gave to reset my board to try again.
Anyone know what I should do? Tried googling my way, but can't find any clues.