In the morning mails I found the shiny new alpha release. Thanks alot! I can tell you it's a pleasure now to run longer/endless routines/loops without interruption.
I also found a few nits:
#1 Email: The howto deploy statement in the mail says
"esptool.py --port /dev/ttyUSB0 --baud 460800 write_flash --flash_size=8m 0
mp-esp8266-firmware.bin" whereas the name of the binary is "-v01" longer.
#2 After successfully flashing and evoking REPL, I receive the following output with about 20 seconds interval between the output lines:
Code: Select all
>>> chg_A3:-180
chg_A3:0
chg_A3:-180
chg_A3:0
chg_A3:-180
chg_A3:0
chg_A3:-180
chg_A3:0
#3 Quickref at http://micropython.org/resources/docs/e ... networking
In oder to get the useful function do_connect() to do its work I had to change line 3:
Code: Select all
- wlan = network.WLAN(wlan.STA_IF)
+ wlan = network.WLAN(network.STA_IF)
Code: Select all
>>> do_connect()
Traceback (most recent call last):
File "<stdin>", line 1, in <module>
File "<stdin>", line 3, in do_connect
NameError: local variable referenced before assignment
Please stop me if this is not the favoured way to feedback.
PS: My preliminary testing setup/device is an ESP8266 ESP-01 512K (flash_id Manufacturer: c8, Device: 4013)