Disable UART1 boot messages

All ESP8266 boards running MicroPython.
Official boards are the Adafruit Huzzah and Feather boards.
Target audience: MicroPython users with an ESP8266 board.
User avatar
kfricke
Posts: 342
Joined: Mon May 05, 2014 9:13 am
Location: Germany

Re: Disable UART1 boot messages

Post by kfricke » Tue Jun 20, 2017 7:00 am

...of course devices connected to the ESP32 and not the same device connected to an other Micropython host.

User avatar
rdagger
Posts: 87
Joined: Tue Feb 28, 2017 6:16 pm
Contact:

Re: Disable UART1 boot messages

Post by rdagger » Wed Jun 21, 2017 5:12 pm

kfricke wrote:If the two lost bytes are reproduceable when using other devices, you should file a bug report!
Yes, I connected the ESP32 via serial to a Pi and observed the same behavior. Should I just post an issue at https://github.com/micropython/micropython-esp32?

User avatar
kfricke
Posts: 342
Joined: Mon May 05, 2014 9:13 am
Location: Germany

Re: Disable UART1 boot messages

Post by kfricke » Wed Jun 21, 2017 9:37 pm

rdagger wrote:Should I just post an issue at https://github.com/micropython/micropython-esp32?
Aye

Post Reply