I am just getting started with micropython and esp32.
I tried using the esp32-20171112-v1.9.2-443-g236297f4.bin image from
http://micropython.org/download#esp32
But I do not get the repl prompt.
(My system is linux and I use minicom -D /dev/ttyUSB1 -b 115200)
Only after pressing the "en" button on the board does it appear.
However, it does not accept any keyboard input.
I would like to check with older images before filing a bug report.
Is there an archive for those somewhere?
older esp32 pre-build images / is repl broken
- pythoncoder
- Posts: 5956
- Joined: Fri Jul 18, 2014 8:01 am
- Location: UK
- Contact:
It works here
I can find no problem with this build. I've connected with rshell and miniterm (115200, /dev/ttyUSB0) without issue. Check that you used the right esptool invocation as per http://micropython.org/download#esp32.
Peter Hinch
Index to my micropython libraries.
Index to my micropython libraries.
Re: older esp32 pre-build images / is repl broken
Problem solved: Hardware Control Flow was enabled and needed to be turned off.
For minicom the settings are hidden in
Menu::cOnfigure Minicom::Serial port setup
For minicom the settings are hidden in
Menu::cOnfigure Minicom::Serial port setup