Roberthh wrote: ↑Thu Aug 23, 2018 5:16 pm
I recorded firmware
Do you mean you flashed the firmare to the device.
By which means did you do that. A convenient way is to use the command:
make deploy
And after flashing the firmware to the device you get a REPL prompt?
I'm using esptool (windows), example:
Code: Select all
esptool.py - esp32 chip --port com6 write_flash 0x01000. \ firmware.bin
PS1. Because the server is distant, I compile the firmware, transfer it via FTP and record it as a esptool in Windows.
PS2. I already use this method to write esp8266 firmware without any problem
yes repl works
when exec repl, after password confirmation
Would you like to reboot now? (y / n)
I receive the following error message
Code: Select all
Guru Meditation Error: Core 0 panic'ed (IllegalInstruction)
. The exception was unhandled.
Guru Meditation Error: Core 0 panic'ed (IllegalInstruction)
. The exception was unhandled.
Guru Meditation Error: Core 0 panic'ed (IllegalInstruction)
. The exception was unhandled.
Guru Meditation Error: Core 0 panic'ed (IllegalInstruction)
. The exception was unhandled.
Guru Meditation Error: Core 0 panic'ed (IllegalInstruction)
. The exception was unhandled.
The same applies to
otherwise esp32 works normally