I have purchased ESP32 module (board says its ESP32 DEVKIT V1), its simple ESP32 module with soldered out pins, micro usb and couple of buttons;
First thing I did was erasing its flash with esptool.py, than accoding to this website guide I've downloaded and flashed latest stable firmware available.
Things went smooth, module turned on and I've connected to it with Tera Term.
Next step was is setting up WebREPL. I've followed guide aswell (its for 8266 as far as I understood, but process should be same),
Did import webrepl_setupd, executed it, pressed E, entered simple password and restarted. However, no network appeared, so I did
import network
ap_if = network.WLAN(network.AP_IF)
ap_if.active(True)
access point started with following log:
Code: Select all
W (100946) phy_init: failed to load RF calibration data (0x1102), falling back to full calibration
I (101096) phy: phy_version: 3960, 5211945, Jul 18 2018, 10:40:07, 0, 2
I (101106) wifi: mode : softAP (24:0a:c4:31:f1:21)
after that I did webrepl.start() which reported me
Code: Select all
WebREPL daemon started on ws://192.168.4.1:8266
Started webrepl in normal mode
While terminal shows
Code: Select all
WebREPL connection from: ('192.168.4.2', 51179)
Traceback (most recent call last):
File "webrepl.py", line 42, in accept_conn
File "websocket_helper.py", line 34, in server_handshake
OSError: Not a websocket request
WebREPL connection from: ('192.168.4.2', 51180)
I (130726) wifi: station: 38:d4:0b:a0:30:2b leave, AID = 1
I (130726) wifi: n:1 0, o:1 0, ap:1 1, sta:255 255, prof:1
Thanks in advance!