MicroPython minimal port on NUCLEO F446ZE
Posted: Tue Jul 23, 2019 4:54 pm
Hi,
I'm trying to execute the minimal port of micropython on the NUCLEO - F446ZE. As the README file says, it should work on STM32 F4 series. However, that's not the case. The code is actually writen succesfully on the board through ST-LINK and the Micropython initializes as expected showing the following: 'MicroPython v1.11 on 2019-07-23; minimal with unknown-cpu'.
The problem occurs when trying to write any line of code. It doesn't matter if it's a variable definition or a print, micropython crashes showing nothing on the console.
Has anyone been through the same or any ideas on how to solve this?
Thanks.
I'm trying to execute the minimal port of micropython on the NUCLEO - F446ZE. As the README file says, it should work on STM32 F4 series. However, that's not the case. The code is actually writen succesfully on the board through ST-LINK and the Micropython initializes as expected showing the following: 'MicroPython v1.11 on 2019-07-23; minimal with unknown-cpu'.
The problem occurs when trying to write any line of code. It doesn't matter if it's a variable definition or a print, micropython crashes showing nothing on the console.
Has anyone been through the same or any ideas on how to solve this?
Thanks.