Nut mounted to bottom of sensor tile

The official PYBD running MicroPython, and its accessories.
Target audience: Users with a PYBD
Post Reply
User avatar
fos
Posts: 42
Joined: Sat Feb 18, 2017 3:05 pm
Location: Texas and Kansas
Contact:

Nut mounted to bottom of sensor tile

Post by fos » Thu Jun 06, 2019 12:58 am

Are the screw size and thread pitch for the nut that is mounted to the bottom of the sensor tile available? It mates up to the holes in the back
plane board. I searched the documentation unsuccessfully.

I don't want to take the sensor tile to the hardware store to determine its size unless necessary.

Thank you,
v/r
Jeff

User avatar
jimmo
Posts: 311
Joined: Tue Aug 08, 2017 1:57 am
Location: Sydney, Australia

Re: Nut mounted to bottom of sensor tile

Post by jimmo » Thu Jun 06, 2019 10:08 am

fos wrote:
Thu Jun 06, 2019 12:58 am
Are the screw size and thread pitch for the nut that is mounted to the bottom of the sensor tile available? It mates up to the holes in the back
plane board. I searched the documentation unsuccessfully.
I'm fairly sure they're M1.6 thread.

The 3D model in the reference schematics is SMTSO-M1.6-1ET-PennEngineering-09-15-2017.stp

User avatar
fos
Posts: 42
Joined: Sat Feb 18, 2017 3:05 pm
Location: Texas and Kansas
Contact:

Re: Nut mounted to bottom of sensor tile

Post by fos » Thu Jun 06, 2019 10:24 am

Thank you, Sir.

I will go to the hardware this weekend and report back the specifications.

Jeff

Post Reply