Page 1 of 1

Nut mounted to bottom of sensor tile

Posted: Thu Jun 06, 2019 12:58 am
by fos
Are the screw size and thread pitch for the nut that is mounted to the bottom of the sensor tile available? It mates up to the holes in the back
plane board. I searched the documentation unsuccessfully.

I don't want to take the sensor tile to the hardware store to determine its size unless necessary.

Thank you,
v/r
Jeff

Re: Nut mounted to bottom of sensor tile

Posted: Thu Jun 06, 2019 10:08 am
by jimmo
fos wrote:
Thu Jun 06, 2019 12:58 am
Are the screw size and thread pitch for the nut that is mounted to the bottom of the sensor tile available? It mates up to the holes in the back
plane board. I searched the documentation unsuccessfully.
I'm fairly sure they're M1.6 thread.

The 3D model in the reference schematics is SMTSO-M1.6-1ET-PennEngineering-09-15-2017.stp

Re: Nut mounted to bottom of sensor tile

Posted: Thu Jun 06, 2019 10:24 am
by fos
Thank you, Sir.

I will go to the hardware this weekend and report back the specifications.

Jeff