Code: Select all
[ 3497.923509] usb 2-1: new full-speed USB device number 50 using xhci_hcd
[ 3498.050990] usb 2-1: New USB device found, idVendor=2e8a, idProduct=0005, bcdDevice= 1.00
[ 3498.050993] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[ 3498.050995] usb 2-1: Product: Board in FS mode
[ 3498.050996] usb 2-1: Manufacturer: MicroPython
[ 3498.050998] usb 2-1: SerialNumber: e6609103dr955539
[ 3498.052671] cdc_acm 2-1:1.0: ttyACM0: USB ACM device
Not seeing any device block showing up to replace / reset the UFI file.
Tried holding reset while cycling USB connection. Nope.
Question is the on-board reset button exactly the same as the RUN pin to GND reset button?