Tailoring the Micropython when using the zephyr port
Posted: Fri May 11, 2018 3:09 am
I'm a novice at Micropython.I have tried to use the port of MicroPython to Zephyr RTOS,and the size of the file after compiled is about 165kb flash and 40kb sram.
But the region size of the mcu I am using is 64kb'flash and 8kb's sram.So i want to do some tailoring of Micropython and I was wondering if this is possible?
I have used the "Minimal build" which is a way offered by the official, the size of the ".bin" file is 130kb flash and 25kb sram which is still too large to use on my board.
Is there any one who could offer me some advice and I'll feel so grateful for this.
But the region size of the mcu I am using is 64kb'flash and 8kb's sram.So i want to do some tailoring of Micropython and I was wondering if this is possible?
I have used the "Minimal build" which is a way offered by the official, the size of the ".bin" file is 130kb flash and 25kb sram which is still too large to use on my board.
Is there any one who could offer me some advice and I'll feel so grateful for this.