Hi Robert,
Please find the O/P of port_diag ... I see 4 MB
>>> import port_diag
FlashROM:
Flash ID: 1640e0 (Vendor: e0 Device: 4016)
Flash bootloader data:
Byte @2: 00
Byte @3: 40 (Flash size: 4MB Flash freq: 40MHZ)
Firmware checksum:
size: 530896
md5: d5b8fdbc4aca895baf9581d3a961dd73
True
Networking:
STA ifconfig: ('0.0.0.0', '0.0.0.0', '0.0.0.0', '208.67.222.222')
AP ifconfig: ('192.168.4.1', '255.255.255.0', '192.168.4.1', '208.67.222.222')
Free WiFi driver buffers of type:
0: 8
1: 0
2: 8
3: 4
4: 7
lwIP PCBs:
Active PCB states:
Listen PCB states:
TIME-WAIT PCB states:
>>>
I've flashed using esptool.py after erase flash ...but no luck
supoduri@SUPODURI-K85W1 MINGW64 ~/esp8266-micropython-vagrant (master)
$ esptool.py -p COM4 erase_flash
esptool.py v1.2-dev
Connecting...
Erasing flash (this may take a while)...
supoduri@SUPODURI-K85W1 MINGW64 ~/esp8266-micropython-vagrant (master)
$ esptool.py -p COM4 --baud 460800 write_flash --flash_size=8m 0 firmware-combined.bin
esptool.py v1.2-dev
Connecting...
Running Cesanta flasher stub...
Flash params set to 0x0020
Writing 532480 @ 0x0... 532480 (100 %)
Wrote 532480 bytes at 0x0 in 12.0 seconds (356.4 kbit/s)...
Leaving...
supoduri@SUPODURI-K85W1 MINGW64 ~/esp8266-micropython-vagrant (master)
$
main.py don't start after poweron
Re: main.py don't start after poweron
Thanks Everyone !
its working now... I was putting on main.py @ /home/vagrant/micropython/esp8266/scripts/ on ubuntu virtual machine (on the same VM where firmware is compiled) ......it didn't work.
Now I'm using mpfshell to put main.py file through serial port. Its working now.
its working now... I was putting on main.py @ /home/vagrant/micropython/esp8266/scripts/ on ubuntu virtual machine (on the same VM where firmware is compiled) ......it didn't work.
Now I'm using mpfshell to put main.py file through serial port. Its working now.