[SOLVED] can't connect to REPL
Re: can't connect to REPL
Reboot as the big hammer should work.
Re: can't connect to REPL
If you get the "busy" error that means that some other process already has the port open.
You should be able to use the lsof command to determine who has the port open:
You should be able to use the lsof command to determine who has the port open:
Code: Select all
$ lsof | grep ttyACM0
Re: can't connect to REPL
[SOLVED!]
Now I found the solution...
1. unplug the pyboard
2. type:
3. plug the pyboard
4. type:
5. figure out the new device, this is the pyboard (in my case: /dev/ttyACM3)
6. then, use this new device address to connect!
For some reasons I have now other devices , so the pyboard is now device number 3.
the solution was found here:
https://subscription.packtpub.com/book/ ... s-the-repl
Now I found the solution...
1. unplug the pyboard
2. type:
Code: Select all
ls /dev/ttyACM*
4. type:
Code: Select all
ls /dev/ttyACM*
6. then, use this new device address to connect!
Code: Select all
sudo picocom /dev/ttyACM3
the solution was found here:
https://subscription.packtpub.com/book/ ... s-the-repl
Re: [SOLVED] can't connect to REPL
I had trouble for a while with the modem manager, which tried to capture the pyboard interface and configure it as a modem. That went away after I uninstalled the modem manager,
Re: Can't connect to REPL
I hook up to ACM0 but do not get the prompt ....
Nor does keyboard type to screen ....
Adafruit board works O.K. on same rig ????
Nor does keyboard type to screen ....
Adafruit board works O.K. on same rig ????