Trying Micropython on my NodeMCU V2 (ESP8266 12-E) development board. Playing with the REPL is fine but when I use main.py and a finite loop it never stops...
Code: Select all
import pyb
pin = pyb.Pin(14, pyb.Pin.OUT_PP)
for i in range(10):
pin.low()
pyb.delay(1000)
pin.high()
pyb.delay(1000)
Also when I connect the virtual terminal to the board I get this repeated with every blink...
Code: Select all
load 0x40100000, len 30800, room 16
tail 0
chksum 0xd8
load 0x3ffe8000, len 1388, room 8
tail 4
chksum 0xa3
load 0x3ffe8570, len 19964, room 4
tail 8
chksum 0xd6
csum 0xd6
...C MEM CHECK FAIL!!!
drl..rl....b....n...nn......l.p......ll.ll.........l..n......b..l..b.......b...b..lrlr.n.......n...
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
load 0x40100000, len 30800, room 16
tail 0
chksum 0xd8
load 0x3ffe8000, len 1388, room 8
tail 4
chksum 0xa3
load 0x3ffe8570, len 19964, room 4
tail 8
chksum 0xd6
csum 0xd6
...C MEM CHECK FAIL!!!
drl..rl....b....n...nn......l.p......ll.ll.........l..n......b..l..b.......b...b..lrlr.n.......n...
What am I missing ????
Thanks....