The GENERIC-S2 port compiled just fine, but it appears to be setup for USB REPL. I can see the system boots, but no interaction on UART.
Next, I tried to simply delete the .usb line in mpconfigboard.h
Code: Select all
set(IDF_TARGET esp32s2)
set(SDKCONFIG_DEFAULTS
boards/sdkconfig.base
boards/sdkconfig.usb
)
if(NOT MICROPY_FROZEN_MANIFEST)
set(MICROPY_FROZEN_MANIFEST ${MICROPY_PORT_DIR}/boards/manifest.py)
endif()
Code: Select all
CONFIG_USB_ENABLED=n
CONFIG_USB_CDC_ENABLED=n
CONFIG_USB_CDC_RX_BUFSIZE=256
CONFIG_USB_CDC_TX_BUFSIZE=256
Is anyone able to point me in the right direction to get the REPL on the UART?