STM32F767IG HARDWARE error

Discussion and questions about boards that can run MicroPython but don't have a dedicated forum.
Target audience: Everyone interested in running MicroPython on other hardware.
Post Reply
ericchu923
Posts: 1
Joined: Thu Oct 11, 2018 5:31 pm

STM32F767IG HARDWARE error

Post by ericchu923 » Thu Oct 11, 2018 6:17 pm

Hello, I am new to MicroPython, I am from Taiwan.
I am having problems with my ALIENTEK STM32F67 apollo board (using STM32F767IG).
I modified the clock configuration of the MCU chip (NUCLEO_F767ZI) similar to my board.
After several compilations, the REPL is able to function properly and can also control the LEDs.
However, it has not been able to enter the REPL at the time of compiling, and the LED status is a slow flashing of the red LED and the green LED.
Here is a short short video with reference: https://youtu.be/DtsyUvpyJqM
And provide a configuration file (on Dropbox) reference: https://www.dropbox.com/sh/yqrki2kd8oot ... WZ8Ga?dl=0
Google Translator helped me ask this question.
If there is any violation of the rules of the forum or offense, please let me know, thank you.

Post Reply